User Guide

Installing the CineMaster C3.0 Card 5
As seen in Table 1, the required hard drive space is even larger when the DVD Root and
Mux directories are not deleted after writing the disc image. These directories each require
the same amount of disk space as the disc image. You may want to retain the Mux directory
to allow for faster subsequent disc image writes; and you may want to retain the DVD Root
directory if you want to the proof those files in an application that supports playing DVD
volumes. The option for deleting the DVD Root and Mux directories is in the Layout Editor
(see “Step 2 – Choosing the Target Directories” on page 251).
Note: The asset files, Mux directory, DVD Root directory, and disc image don’t necessarily
have to reside on the same hard drive. Therefore, four 5 GB hard drives will work just as
well as one 20 GB drive.
File System Considerations
Because the FAT 16 and FAT 32 file systems do not support files larger than 2 GB, you must
use NTFS to format any hard drives that will hold media assets and disc images.
Installing the CineMaster C3.0 Card
Before installing the Scenarist software, first install the CineMaster C3.0 Decoder card, along
with the CineMaster software included on the Scenarist Installation disc.
To Install the CineMaster C3.0 card:
1 Shut down and power off your computer. Disconnect the power cord.
2 Open the computer (following the manufacturer’s instructions) and locate any available
PCI expansion slot.
3 Remove the slot cover screw and slot cover if necessary.