User Guide

GO TO
To quickly move the cursor to a specific point and center it in the waveform
display, use the Go To command.You can reach the Go To dialog in a number of
different ways:
• Select the Go To command from the Edit menu
• Right-click on the waveform display and select Go To from the shortcut
menu
• Double-click on the left-most selection status field
• Press Control+G
The Go To dialog is much like the Set Selection dialog described below. You can
type in the location where you want to go or use one of the predetermined
locations from the list.
MAKING A DATA SELECTION USING THE SET
SELECTION DIALOG
If you need to select data at specific points, the Set Selection dialog allows you to
type in selection points or choose a selection from a list of regions. To reach
the Set Selection dialog, choose the Selection command from the Edit menu.
EDITING AND NAVIGATION
50