User Guide

selection on the destination centerline. Otherwise, the selection will be
crossfaded into either the left or right channel only.
DRAG PASTE
To paste a selection into another data window, drag the selection from the
source to the destination window. Press the Alt key while holding the cursor in
the destination window. Processing begins at the point where you drop the
region in the destination file.When pasting a mono selection into a stereo file,
you can paste the selection to both channels by dropping the selection on the
destination centerline. Otherwise, the sound data will be placed in either the
left or right channel only, with silence in the other.
DRAG TO REGIONS LIST
To add the current selection to the Regions List, drag it to the Regions List.
OTHER MOUSE SHORTCUTS
SELECT ALL
Double-click on the waveform display to select the entire sound file. Triple-
click if Regions and Markers exist in the file.
ZOOM BOTH TIME AND LEVEL
Double-click on the Level Ruler to zoom the current selection both vertically
and horizontally. If no selection exists, the entire waveform display data is
zoomed. Double-click again to Zoom Out Full vertically and Zoom Normal
horizontally.
MAGNIFY MODE
To zoom in to a section, select an area while holding the Control key. This will
switch Sound Forge XP to Magnify mode, which zooms to fit the selected area.
RETURN CONTROL VALUE TO DEFAULT
Double-click on a trackbar, fader, or spinner to set it to its default value.
APPENDIX C
262