User Guide

RECORDING
117
You can fine tune a control’s value by holding down both the left and
right mouse buttons at the same time (or holding down Control on the
keyboard)
There are many keyboard shortcuts for use with faders and trackbars.You can
use the Up,Down,Left and Right arrow keys to change the value in small increments
or the Page Up and Page Down keys to change the value in larger increments. The
Home and End keys change the parameter value to its maximum or minimum.
If you double-click on a fader or trackbar thumb, it returns to its reset value
(usually 0%, 50%, or 100%). Left-clicking on the hash marks in a fader also
changes the value by very small increments.
EDIT BOX SPINNER CONTROL
In the Dynamics dialog the Attack time and Release time parameters are modified
with edit box spinner controls. The edit box is the box containing text, while
the spinner is the small control to the right.With this type of control, you have
several options for changing a parameter value.You can:
• Type in the number by left-clicking on the edit box and then typing in the
value.
• Increment the value by clicking on the two small up/down buttons.
• Use the spinner to change the value. This is done by left-clicking on the
center button (between the two up/down buttons) and dragging the mouse
up or down. Again, holding down both the left and right mouse buttons at
the same time will cause the values to increment in finer steps.You can also
use the Up/Down arrow keys and Page Up/Page Down keys to alter the value.
• Adjust the spinner while holding down both mouse buttons to see the finer
increment resolution (or hold down the Control key).
NOTE