User Guide

CHP. 5 WORKING IN THE TRACK VIEW
77
Navigating to regions
While you are working on your project, you may have scrolled to a portion of the project where the cursor is
not visible. You may click in the track view to move and view the cursor or you may use region tags to bring
the cursor into view.
To move the cursor to the selected region tag, right-click the region tag and choose
Go To from the shortcut
menu.
Tip: You may also navigate between regions in your project
by pressing +left/right arrow key or the number key (not
on the numeric keypad) corresponding to the region number.
Selecting regions
You may use the region’s start and end tags to make a time selection across all tracks in your project. The
information within the time selection can then be used for playback or editing.
To select a region, right-click a region tag and choose
Select Region from the shortcut menu. The loop bar
appears between the region tags and the tracks are highlighted.
Deleting regions
You may remove regions from the project at any time. Because regions are automatically numbered when
they are placed, ACID does not renumber the existing regions when one is removed. Rather, the existing
regions retain their numbers. However, if you add regions later, ACID begins numbering to fill the sequence
gap that exists.
For example, if you have six regions in your project and delete regions four and five, the remaining regions
are listed as one, two, three and six. When you add regions again, ACID begins numbering the regions as
four and five.
To remove a region from a project, right-click the region tag marker and choose
Delete from the shortcut
menu.
Ctrl
Loop bar