User Manual
Table Of Contents
- Overview
- Model Matrix
- Contents in Box
- Accessories (not included)
- Features
- Common Features, All Models
- Adjustable Volume Control
- Automatic Loud Noise Suppression
- Convertible Headband
- Color Ruggedizers
- Extreme Environmental Design
- Flexible Charging
- Hearing Protection
- In Headset Charging
- Light Weight
- Listen Thru Situational Awareness
- Long Battery Life
- Multilingual Voice Prompts
- Multimode Auto Shutdown
- Noise Dosimeter
- Two Stage Low Battery Alert
- USB Programmable
- User Replaceable Battery
- Voice Prompts
- Wired Line-in
- Common Features, Communication Headsets
- Wireless Bluetooth® Technology
- Wireless DECT Communications
- Common Features, All Models
- Configuring the Headset
- Fitting
- Charging
- Battery Replacement
- LED Indications
- Settings & Operation
- Care and Maintenance
- Troubleshooting
- Glossary
- Specifications
- Important Safety Information
- Sonetics Standard Limited Warranty
5 | Page
Configuring the Headset
The Sonetics power headset may be configured for use as an overhead, under-
helmet, or hart hat (sold separately) headset. The different headbands are attached
through a secure snap joint on the side of the ear domes. This snap joint secures
the headset to the ear dome, maintains the ear dome orientation, and provides a
full motion of freedom to allow the dome to seat comfortable against the user’s
head.
Headband Removal
Tools Required: Headband Removal Tool
1. Use the handle of the Headband Removal Tool
2. Place the handle between the headband and the dome. Note the notch in the
headband to secure the headband removal tool handle.
3. Use one hand to hold the dome on a flat surface
4. Gently push with the headband with the other hand.
5. Route the headband cable into the under headband as shown.
Headband Installation
Tools Required: None
1. Align the headband with the domes as shown.
Over
Head
Behind
Head
2. Place the Dome onto a flat surface.
3. Press Down on the headband till the ball joint snaps into place.