User Manual
Table Of Contents
- Overview
- Model Matrix
- Contents in Box
- Accessories (not included)
- Features
- Common Features, All Models
- Adjustable Volume Control
- Automatic Loud Noise Suppression
- Convertible Headband
- Color Ruggedizers
- Extreme Environmental Design
- Flexible Charging
- Hearing Protection
- In Headset Charging
- Light Weight
- Listen Thru Situational Awareness
- Long Battery Life
- Multilingual Voice Prompts
- Multimode Auto Shutdown
- Noise Dosimeter
- Two Stage Low Battery Alert
- USB Programmable
- User Replaceable Battery
- Voice Prompts
- Wired Line-in
- Common Features, Communication Headsets
- Wireless Bluetooth® Technology
- Wireless DECT Communications
- Common Features, All Models
- Configuring the Headset
- Fitting
- Charging
- Battery Replacement
- LED Indications
- Settings & Operation
- Care and Maintenance
- Troubleshooting
- Glossary
- Specifications
- Important Safety Information
- Sonetics Standard Limited Warranty
14 | Page
Wireless Bluetooth®
To create a new Bluetooth pairing
1. Turn off the headset.
2. Turn on the headset.
3. The headset will enter into Bluetooth pairing mode for the first 10 minutes of
operation.
4. Enter connectivity options on your Bluetooth device and under Bluetooth
search for new devices. Once the search is complete select Sonetics-HS## and if
prompted for a password enter four zeros (0000).
To answer a call
Quickly press and release the menu button.
To hang up a call
Quickly press and release the menu button.
Wireless DECT
The headsets with the DECT communication feature have the ability to use the
Sonetics DECT and IP-DECT wireless bases for communication. The protected
frequency in each region ensures interface free operation. All DECT communication
is full duplex (like a phone call).
Pairing the DECT Headset
The DECT wireless headset uses a semi-permanent link with a DECT base station or
IP-DECT system to remember where to connect each time a connection is
established. No additional steps are required after a headset has been paired to a
base. Each time thereafter the headset will remember the base and automatically
reconnect.
To Create a New DECT Pairing
1. Turn off the headset.
2. Enter the Base Station into Pairing Mode.
3. Hold down the PTT button and Turn on the headset.
4. Keep holding the PTT button till the LED begins to flash Red/Green .
5. Release the PTT button.
6. If Successful, the LED will begin to flash Green .
7. If not, repeat #1.
To erase a DECT pairing, follow the pairing sequence above without entering the
Base Station into Pairing mode.