User Manual

PAIRING

WIRELESS BASE

POWER INTERCOM

PAIR

LINKS

1 2 3 4 5

Multiple Headset Base Station

Multiple Headset Base

The multiple headset base station is equipped with 5 yellow LINK LEDS on the front

panel. Each LINK LED represents a headset position with position #1 represented by

the leftmost LED. The pairing priority is given starting with position #1 and ending

with position #5. It is recommended that pairing to new headsets is done

one headset at a time.

1.When the base station is first powered, the green LED labeled POWER on the

bottom left of the front panel will illuminate steadily. Every one of the five LINK

yellow LEDs will either stay unlit, indicating that no headset has been previously

paired to that particular headset slot, or will start flashing rapidly indicating that a

headset has been previously paired to that particular headset slot

but is not

currently connected.

NOTE: If any headsets have been previously paired to the base station

and the intent is to keep them paired, then these headsets must remain

turned on and connected in steps 1 through 3 of this procedure. An active

connection to a headset is indicated by the respective LINK LED on the

front panel of the base station being steadily illuminated.

2.Press and hold the pairing button in the bottom right corner of the base station

for approximately 5-7 seconds. The respective LINK LEDs for any headset that is

currently connected to the base station will remain steadily illuminated. However,

LINK LEDS for vacant slots and for occupied slots with no actively connected head-

sets will start flashing slowly to indicate that the base station has been placed in

pairing mode and that these slots have been made available for pairing. The

highest priority slot will be assigned to the headset currently being paired. Once

the base station is placed in pairing mode, the user has approximately 15 seconds

to place the headset in pairing mode.