Manual

WIRE GAUGE CHART
WIRE GAUGE
18 Gauge
16 Gauge
14 Gauge
12 Gauge
10 Gauge
DISTANCE
Up to 100 feet (30 meters)
Up to 150 feet (45 meters)
Up to 250 feet (80 meters)
Up to 400 feet (122 meters)
Up to 650 feet (198 meters)
Types of wire
Color-coded, 14/4 direct-burial speaker wire is recommended.
NOTE: Please refer to the wiring chart below to determine
which size wire to use over a given distance.
BEST PRACTICE: ‘14/4’ refers to 14 gauge, 4-conductor
wire. It is important to use only ‘direct burial’ wire to
maintain long-term signal integrity and prevent corrosion
from occurring to the wire. Using individual conductors
with different colors makes it easy to identify and access
both amplifier channels. Low voltage lighting wire can
also be used but is only sold as a 2 conductor wire. If
using a 2 conductor wire, then run two pairs of wires;
one for each amplifier channel (Right/Left).
Left Right Right Left Left Right Right Left
Left and Right
SR1 SATs & SR1 SUB
SR 2-125 Amplifier
SONARRAY SR1 SYSTEM Wiring Diagram 8 ohm
Configuration: 8 SATs to 1 SUB (all 8 SATs must be used) Non-expandable
T5AL / 250VAC
CAUTION
REPLACE FUSE ONLY
WITH
SAME TYPE AND RATING
ATTENTION
REMPLACER UNIQUEMENT AVEC
LE MEME TYPE ET CALIBRE DU
FUSIBLE
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
1 - LEFT
1 - RI
G
HT
AC 100-120V ~ 60Hz
AC 220-240V ~ 50Hz
81 watts
S/
N
MADE IN CHINA
SONARRAY SR 2-125
IN
OUT
IN
OUT
Use Only One Type Of Input Connection
EQ PRESET
SELECTION
L R
L&R L&R
COAX TOSLINKANALOG ANALOG
See Manual for EQ Preset List
EQ
PRESET
BANK
2
AUTO
ON
OFF
AUDIO
ON
1
4
3 5
6
7
EQ1
FLAT
EQ3
EQ2 EQ4
EQ5
EQ6
CLASS 2 WIRING
4
ΩMIN
Figure 2
Note: The subwoofer
can be connected at any
point in the daisy chain.
Speaker Installation
1. Place the 8 satellites and 1 subwoofer in their approximate
final locations.
2. Dig a 4” to 5” trench to run the speaker wires in.
3. Starting at the amp location or wire connection point, run the
speaker wire through the trench to the first speaker location.
Connecting the Speakers
The SONARRAY SR1 SYSTEM allows the satellite speakers to
be wired together in a parallel-daisy chain configuration. In a
typical system with one zone of audio, simply run a 4 conductor
wire from the amplifier or connection point to the closest speaker.
Once you have designated the first speaker as either left or right,
continue alternating the wires between the left and right channels
creating a daisy chain of stereo satellites. See figure 2.
3