Owners Manual

3
S O N A N C E C I N E M A S U B
A C O U S T I C E N C L O S U R E
Insulating the Wall Cavity
Subwoofer performance can be enhanced by insulating the cavities
above and adjacent too the enclosure with fiberglass insulation.
This added fiberglass will minimize any noise that could be caused
by the unsupported drywall resonating.
Drywall and Screw Installation
To maximize performance and minimize noise and vibration it is
strongly recommended that one complete piece of drywall be
installed over the subwoofer location as shown above.
Drywall screws should be installed at a spacing of 8"-10" (203-
254mm). If drywall is installed on the wall surface behind the
subwoofer enclosure drywall screws should also be installed
following these instructions as well.
IMPORTANT: DO NOT INSTALL DRYWALL SCREWS INTO THE
ENCLOSURE. THE ENCLOSURE IS DESIGNED TO FLOAT INSIDE
THE WALL.