Installation Manual

SONANCE
|
PROFESSIONAL SERIES IN-CEILING
|
INSTALLATION MANUAL6
INSTALLATION
STANDARD INSTALLATION
STEP 1
Cut a hole in the drywall using the supplied cutout template
(see figure 4).
NOTE: FOR DROP-CEILING INSTRUCTIONS REFER TO PAGE 7
STEP 2
Connect the wires from your amplifier to the Euroblock connector
(see figure 5).
Pin 1 + Positive In
Pin 2 - Negative In
Pin 3 + Positive Out
Pin 4 - Negative Out
Strip approximately .1875” (5mm) of the insulation off each wire.
Insert the wire into the correct square opening on the connector.
Use a small flat head screwdriver to tighten the corresponding
screw to secure the wire (see figure 6).
When using multiple speakers you can connect the speakers either
in parallel or in the loop through method as shown (see figure 7 & 8).
STEP 3
Once all the wires are terminated. Plug the green Euroblock
connector into the back of the speaker (see figure 9).
Route the wires through the Strain Relief Fitting on the back of
the speaker. Tighten the screws on the strain relief to clamp the
wires. Make sure not to over-tighten the screws and damage the
wire (see figure 10).
NOTE – IF SQUARE GRILLES ARE BEING USED THE ADAPTER
FRAME MUST BE INSTALLED AT THIS TIME.
Parallel Connection To Next SpeakerFrom Power Amplifier
Loop Thru Connection To Next SpeakerFrom Power Amplifier
From Power Amplifier
Parallel Connection
To Next Speaker
Parallel Connection To Next SpeakerFrom Power Amplifier
Loop Thru Connection To Next SpeakerFrom Power Amplifier
From Power Amplifier
Loop Through Connection
To Next Speaker
FIGURE 4:
CUTOUT TEMPLATE
FIGURE 8: LOOP THROUGH CONNECTION
FIGURE 7: PARALLEL CONNECTION
FIGURE 5:
EUROBLOCK CONNECTOR
FIGURE 6:
SECURE THE WIRE
FIGURE 9:
PLUG IN
EUROBLOCK
CONNECTOR
FIGURE 10:
ROUTE WIRES &
TIGHTEN SCREWS
+
_
IN OUT
+
_