Quick Start Guide

©2014 Sonance. All rights reserved.
Sonance and Architectural Series are registered trademarks of Dana Innovations.
Due to continuous product improvement, all features and specifications are subject to change without notice.
For the latest Sonance product specification information, visit our website: www.sonance.com
SONANCE • 212 Avenida Fabricante • San Clemente, CA 92672-7531 USA
[phone] or [phone] • FAX: [phone] • Technical Support: [phone]
www.sonance.com
06.05.1433-5946
On the end of the BPS6 port tube there is a tether.
The tether will be used later to guide the BPS6 port
tube through the mounting platform opening.
Position end of port tube as close as possible
to back of mounting platform. Loop tether into
the anchored zip tie and secure. This process
ensures that bandpass connector is easily
attached later and other tradespersons won’t
infringe on port tube assembly area.
5 6
7 8
Tether into
zip tie
Tether
For wiring diagrams &
detailed eManual scan
the QR code or visit
www.sonance.com/
in-wall-in-ceiling/
architectural-series
Secure the wires with a zip tie near the
terminals to prevent accidental removal by
another tradesperson.
Attach the four conductor wires from the
amplifier to the input terminals on the end of
the BPS6. Positive wires to red terminals and
negative wires to black terminals. Run the
speakers wires to amplifier location and run
signal test with 9V battery. NOTE: Port tube
contains foam plug with tether, make sure
pressure levels don’t expel the foam and
tether. Do not connect the voice coils
in parallel.