Instruction Manual

6
49. The actual instruction manual can be downloaded from www.somogyi.hu website.
50. We don’t take the responsibility for printing errors which may occur, and apologize for them.
Caution: Risk of electric shock! Do not attempt to disassemble of modify the unit or its
accessories. In case any part is damaged, immediately power off the unit and seek the
assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by
the manufacturer, its service facility or similarly qualified personnel.
DO NOT COVER!
COVERING THE UNIT CAN CAUSE OVERHEATING, FIRE OR ELECTRIC
SHOCK.
THE REMOTE CONTROL IS NOT A TOY. KEEP OUT OF REACH OF CHILDREN.
THIS REMOTE CONTROL INCLUDES A BUTTON BATTERY. IT IS FORBIDDEN TO
SWALLOW THE BATTERY, RISK OF CHEMICAL BURN. IN CASE OF INGESTION,
IT MAY CAUSE STRONG INTERNAL BURN WITHIN 2 HOURS AND MAY LEAD TO
DEATH. KEEP THE NEW AND USED BATTERIES OUT OF REACH OF CHILDREN. IF
THE COVER OF THE BATTERY COMPARTMENT CANNOT GET CLOSED SECURELY,
DO NOT CONTINUE TO USE THE PRODUCT AND KEEP IT AWAY FROM CHILDREN.
IF YOU THINK THAT A BATTERY HAS BEEN SWALLOWED OR GOT INTO ANY BODY
PARTS, SEEK MEDICAL ATTENTION IMMEDIATELY.
Order of MOUNTING ON WALL, INSTALLING
1. Before switching on for the first time, carefully remove the packaging material taking care
not to damage the appliance and power cable. Do not use the product if it is damaged in
any way!
2. The device may only be used in dry indoor conditions!
3. The free flow of warm air must be ensured for proper operation, therefore, please select the
location for wall mounting according to Figure 2. Do not locate the appliance directly below
a wall outlet!
4. In order to insert the wall studs, drill holes with appropriate size into the wall, at least 200 cm
from the floor, along a horizontal line and 315 mm from each other.
5. Insert the studs into the holes then drive the enclosed screws into the studs so that the screw
heads
6. extend approx. 10 mm from the wall surface.
7. Hang the unit’s rear panel onto the screw heads at the holes, let it down, till stop. Make sure
that the heater is hanging securely on the wall!
8. Connect the unit’s power cable into a standard grounded wall outlet!