Operation Manual

7
Safety instructions
CAUTION!
Important instructions for safe installation.
Observe all installation instructions – improper installation
can lead to serious injuries!
¾ The power cable supplied as standard may be neither shortened nor
lengthened.
¾ The voltage of the power source must correspond to that indicated
on the drive's rating plate.
¾ All devices requiring external connection must be equipped with safe
contact separation as per IEC 364-4-41 to isolate them from the mains
voltage supply.
¾ Live parts of the drive (voltage-carrying parts e.g. C-rails) may not
be connected to earth or to the live parts or protective conductors
of other circuits.
¾ IEC 364-4-41 must be observed when laying the external device
conductors.
CAUTION! RISK TO LIFE AND LIMB!
Remove all ropes and loops that are required for the manual
operation of the door.
Tools required
Mit SOMMER sind Sie immer gut ausger
ichtet!
10 mm
13 mm
2x 17 mm
5 mm
6 mm
10 mm
10 mm
Personal protective equipment
¾ Protective goggles (for drilling)
¾ Protective gloves (e.g. for handling cut perforated steel strips)
Installing a wicket door safety
facility or release lock
• The door is tted with a wicket door, but no wicket door safety facility
⇒ Install a wicket door safety facility (see “Accessories” instructions).
• The door has no wicket door and the garage has no separate entrance
⇒ Install a release lock or Bowden wire to facilitate release from the
outside (see “Accessories” instructions).
Preparations for installation