Operation Manual

22
Important information
DANGER!
Never use a hose or a high-pressure cleaner to spray down
the drive or the control housing.
¾ Always disconnect the drive mechanism from the power supply before
carrying out any work.
¾ Never use lyes or acids for cleaning purposes.
¾ Wipe drive clean with a dry cloth as required.
¾ Keep your hands clear of any moving door or any moving parts.
¾ Risk of persons trapping or cutting themselves in/on the door system's
moving parts or edges where it closes.
¾ All xing screws on the drive should be properly checked and tightened
if necessary.
¾ Check the door at least annually, in accordance with the manufacturer’s
instructions.
Cleaning chain and drive unit rail
7
8
BACK
HINTEN
1. The chain (7) or the drive rail (8) is dirty – clean it with a cloth.
2. If required, lubricate the chain (7) and the drive rail (8) with conductive
oil. Do not use grease!
NOTE!
Recommended oil types: Ballistol, WD40 contact spray.
Changing bulbs
1. Disconnect plug from the socket.
A/B/C
2
3
2. Remove light diffuser (2).
3. Turn bulb (3) anticlockwise and remove.
4. Fit new bulb (32.5 Volt, 34 Watt, BA 15 s or 24 Volt, 21 Watt, BA 15 s)
and turn clockwise until it locks into position.
Changing fuses
(connecting warning lamp)
1. Disconnect plug from the socket.
1
2
3
8
9
10 11
12
7
5
2. Remove light diffuser (2).
3. Remove screws (1).
4. Pull out the control (3).
5. Replace defective fuse, all fuses are 1 A fast acting.
Fuse (5) for connecting warning lamp, terminal 11 + 12.
Maintenance and care