Operation Manual

Functions and connections
21
Partial opening (DIP 8)
This function opens the door partially, depending on the given setting.
Ideas for use: garage ventilation, opening of side-opening door for personal
access, to name but a few. Partial opening can also occur using just two
push-buttons or just the manual remote control.
2
1
ON
3
4
5
6
8
7
DIP switch 8
OFF deactivated
ON activated, DIP switch 7 not functioning
Partial opening with 2 push-buttons
Fit additional push-button and connect as push-button 2 to terminals 1 + 2.
• Push-button 1always opens door fully.
If the door has been partially opened by pressing push-button 2, it can
be fully opened by pressing push-button 1.
• Push-button 2 only carries out partial opening when the door is closed.
Should the door have been fully opened using push-button 1 or partially
opened with push-button 2, it can be closed by again pressing push-
button 2.
Procedure:
1. Closing door.
2. DIP switch 8 ON: activates partial opening.
⇒ Always leave DIP switch 8 in ON position; the OFF position
automatically deletes the partial opening function that has been set.
3. Press push-button 2 (opens door from CLOSED end position).
⇒ door opens until such time as push-button 2 is pressed again
or OPEN end position has been reached.
4. Press push-button 2 when the desired position has been reached.
5. Close door by pressing push-button 2.
Partial opening has been memorised and door is opened
to set position by pressing push-button 2. Set DIP switch 8
to OFF position to delete partial opening setting.
Partial opening via hand-held transmitter
(2-channel operation)
Teaching in 2 hand-held transmitters. E.g. push-button 1 on to radio
channel 1 and push-button 2 on to channel 2
• Radio channel 1 always has the same function as push-button 1
• Radio channel 2 always has the same function as push-button 2
Connecting an external aerial
Supplied vacant as standard
2
1
O
N
DIP
3
4
5
6
8
7
6
TorMinal interface
See TorMinal operating instructions
2
1
ON
3
4
5
6
7
5
6
Trolley board
5
2
1
4
6
7
8
3
Terminal 1 Power supply to chain
Terminal 2 Power supply to rail
Terminal 3 + 4 End switch Door OPEN
Terminal 5 Motor cable
Terminal 6 Motor cable
Terminal 7 + 8 End switch Door CLOSED