Operation Manual

Operation/handling
18
Programming of hand-held transmitter
1. Press the programming key (1)
▫ 1 x for channel 1, LED (3.1) is on
▫ 2 x for channel 2, LED (3.2) is on
⇒ If no other code signal is transmitted within 10 seconds, the radio
receiver switches to standard operation.
2. Press and hold desired hand-held transmitter key (5) until the LED
(3.1/3.2) is off (depending on the selected channel).
⇒ The LED is off – the programming process is completed.
⇒ The hand-held transmitter has transmitted the radio codes
to the radio receiver.
3. Continue with programming the other hand-held transmitters.
To do this, repeat the above steps. The maximum number of memory
blocks is 112 per radio receiver.
Aborting programming:
repeatedly press the programming key (1) until all LEDs are off.
Deleting the hand-held transmitter key
from the radio receiver
If a user of a multi-user garage facility moves house and wants to take
his manual remote control with him, then all the codes of the given user's
manual remote control have to be deleted from the radio receiver.
For security reasons, each key and each key combination of the hand-held
transmitter should be deleted!
1. Press and hold the programming key (1) for 5 seconds.
⇒ An LED ashes (doesn´t matter which).
2. Release the programming key (1).
⇒ Radio receiver is in delete mode.
3. Press a key on the hand-held transmitter, the code of which is required
to be deleted.
⇒ LED goes out. Deletion process complete.
4. Repeat procedure for all the keys and key combinations.
Deleting a channel from the radio
receiver
1. Press and hold the programming key (1).
▫ 1 x for channel 1, LED (3.1) is on
▫ 2 x for channel 2, LED (3.2) is on
⇒ After 5 seconds, the LED (3.1 or 3.2) ashes.
⇒ After another 10 seconds, the LED is constantly on (3.1 or 3.2).
2. Release the programming key (1).
⇒ Deletion process complete.
Clearing radio receiver memory
If a hand-held transmitter is lost, then for security reasons all channels on
the receiver have to be deleted! After this has been done, all the hand-held
transmitter controls must be re-set into the receiver.
1. Press and hold the programming key (1).
⇒ After 5 seconds, the LED (3.1 or 3.2) ashes.
⇒ After another 10 seconds, the LED is constantly on (3.1 or 3.2).
⇒ After a total of 25 seconds, all LEDs are on (3.1 + 3.2).
2. Release the programming key (1). All channel data has been deleted.
Connecting an external aerial
An external aerial can be tted if the possible range with the radio receiver's
internal aerial is insufcient.
Connect the external aerial (6) to the terminal (4), see chapter “Operation/
handling – description of display and push-buttons”.
The aerial cable must not exert any mechanical load on the radio receiver.
Fit strain relief.
What is push-button 2 used for?
Dened opening and closing (2-channel operation). This enables the door
to be opened using one push-button, and closed using another.
Should this function be used, a 2nd push-button can be connected.
For settings see chapter “Functions and connections – connecting
push-button 2” as well as chapter “Functions and connections – dened
opening and closing (DIP 7)” and “partial opening (DIP 8)”.