Operation Manual
16
Safety instructions
¾ Keep children, disabled persons and animals away from the door.
¾ Keep your hands clear of any moving door or any moving parts.
¾ Only drive into and out of the garage when the door is fully opened.
¾ Risk of persons trapping or cutting themselves in/on the door system's
moving parts or edges where it closes.
Opening door
1
1. Press push-button (1) or hand-held transmitter key once to open the door.
2. With door “OPEN”, press the push-button (1) again.
⇒ The door stops moving (dependent on the DIP switch 7).
3. Press the push-button (1) again.
⇒ The door closes (dependent on the DIP switch 7).
Closing door
1. Press push-button (1) or hand-held transmitter key once to close the door.
2. With door “CLOSE”, press the switch (1) again.
⇒ The door stops moving (dependent on the DIP switch 7).
3. Press the push-button (1) again.
⇒ The door opens (dependent on the DIP switch 7).
Pulse sequence of door movement
Adjust the pulse sequence with DIP switch 7.
1x
1x
1x
1x
STOP STOP
2
1
O
N
D
IP
3
4
5
6
8
7
T
1
DIP 7 OFF, default settings for all drives
(see illustration):
• open - stop - close - stop - open - ...
DIP 7 ON:
• Push-button 1: open - stop - close - stop - ...
• Push-button 2: close - stop - close - stop - ...
Emergency release
CAUTION!
The emergency release may only be used in the event of an
emergency, (power failure, failure of drive, etc.) to open or
close the door. Do not use it to open and close the door in
other situations. This could damage the door or the drive
mechanism.
RISK OF SUDDEN CLOSING OR OPENING!
When the emergency release is actuated, the door might
suddenly be opened or closed, due to a damaged spring or
incorrect balance weight. This might damage or even destroy
the drive unit.
NOTE!
Engaging or disengaging the drive can occur in any door
position.
FRONT
VORNE
N
1. Pull once on the emergency release wire (N).
⇒ the drive mechanism disengages and the door can be opened
manually.
2. Pull once again on the emergency release wire (N).
⇒ the drive mechanism locks and the door can only be moved with
the drive.
NOTE!
Door is tted with a wicket door but no safety mechanism
for the wicket door – retro-t wicket-door safety mechanism
(see “Accessories” instructions).
Door has no wicket door and garage no second entrance –
install release lock or Bowden wire providing outside release
access (see “Accessories” instructions).
Control reset
T1
24V/1.0A
supply
safety
+
2
1
7
89
10
1. Press switch (1) until the light bulb (2) goes out.
⇒ Light bulb (2) out – force setting deleted
2. Release the switch (1).
⇒ Light bulb (2) ashes – control reset successful
Operation/handling