Operation Manual

Commissioning
15
Checking emergency release
NOTE!
With sectional doors, or doors with ceiling guides, you have
the option of activating the backjump with DIP switch 6
in order to ofoad the operator and door mechanisms.
Easier operation of the emergency release.
FRONT
VORNE
N
V
1
1. Close the door with the drive.
2. Pull the emergency release (N) once.
If the emergency release cannot be operated, loosen the end switch (V)
and move it in direction (1).
3. Open the door with the drive and close it again. Test the emergency
release.
Checking force setting
Whenever the door is opened or closed, the control unit compares the
memorised force setting with the force actually needed and automatically
adjusts the memorised setting accordingly when the given end position
is reached.
Check: See chapter “Maintenance and care – regular checks”.
Programming of hand-held
transmitter
NOTE!
Prior to the initial programming of the hand-held transmitters,
clear the memory of the radio receiver.
5
T
2
3.1
3.2
1
7
8
4
5
6
5
3.1
3.2
1
Clearing radio receiver memory
1. Press and hold the programming key (1).
⇒ After 5 seconds, the LED (3.1 or 3.2) ashes.
⇒ After another 10 seconds, the LED is constantly on (3.1 or 3.2).
⇒ After a total of 25 seconds, all LEDs are on (3.1 + 3.2).
2. Release the programming key (1). All channel data has been deleted.
Programming of hand-held transmitter
1. Press the programming key (1).
▫ 1 x for channel 1, LED (3.1) is on
▫ 2 x for channel 2, LED (3.2) is on
⇒ If no other code signal is transmitted within 10 seconds, the radio
receiver switches to standard operation.
2. Press and hold desired hand-held transmitter key (5) until the LED
(3.1/3.2) is off (depending on the selected channel).
⇒ The LED is off – the programming process is completed.
⇒ The hand-held transmitter has transmitted the radio codes
to the radio receiver.
3. Continue with programming the other hand-held transmitters.
To do this, repeat the above steps. The maximum number of memory
blocks is 112 per radio receiver.
Aborting programming
repeatedly press the programming key (1) until all LEDs are off.
Attaching instruction label
N
BACK
HINTEN
BACK
HINTEN
46502V000-172006-0-OCE_R
ev.A
1
x
1
x
1x1x
46502V000-172006-0-
OCE_
R ev
.A
A
B
N
Attach the instruction label for the operation of the emergency release
to the emergency release rope.
Attaching warning sign
1.
1.
2.
2.
Attach the warning signs (text + triangle sign) at a position where they are
clearly visible, e.g. beside the push-button (warning triangle) and on the
door leaf (text + warning triangle).