Operation Manual

Commissioning
14
Setting door OPEN + CLOSED
end positions
NOTE!
While adjusting the settings, open and close the gate manually.
Do not operate it with the engaged drive system.
The distance over which the drive mechanism moves the door can be
increased/reduced by using the switch trigger (V + H).
Check that the door opens and closes completely. If it does not, its travel
or the end positions must be adjusted.
BACK
HINTEN
FRONT
VORNE
H
N
1
1
N
V
Door CLOSED end position
1. Release the trolley. Pull once on the emergency release wire (N).
It must be possible to slide the trolley back and forth by hand.
2. Manually close the door.
3. Release the switch trigger (V) and slide it towards the trolley until it clicks.
⇒ The end switch switches on
4. Secure the switch trigger (V).
Door OPEN end position
1. Manually open the door.
2. Release the switch trigger (H) and slide it towards the trolley until it clicks.
⇒ The end switch switches on
3. Secure the switch trigger (H).
4. Manually close the door.
Lock the trolley (1)
1. Pull once on the emergency release wire (N).
2. Move the trolley by hand slightly forwards until the
⇒ chain wheel engages with a loud clicking sound.
Teaching in drive
The control has an automatic force setting. Whenever the door “OPENS”
or “CLOSES”, the control unit automatically reads in the force required and
memorises it when the end position is reached.
CAUTION!
Before connecting the power supply, ensure that the voltage
of the power source corresponds to that indicated on the
drive´s rated plate.
1. Plug in the power supply.
⇒ Lamp (2) ashes
1
2
NOTE!
The rst movement of the drive after the power is connected
must be “door OPEN”. If this is not the case, exchange the
wires to terminals 3 + 4.
2. Press the push-button (1).
⇒ The door opens to end position “door OPEN”.
3. Press the push-button (1).
⇒ The door closes until end position “door CLOSED”.
4. Resetting the control unit. The control reset is carried out in accordance
with the procedure for the given drive type: See chapter “Operation/
handling – control reset”.
Carry out the following procedure twice
1. Press the push-button (1) once.
⇒ Door opens as far as the switch trigger (H, door OPEN)
⇒ Lamp (2) ashes
2. Press the push-button (1) once.
⇒ Door closes as far as the switch trigger (V, door CLOSED)
⇒ Lamp (2) ashes
3. When all force values are read and saved, the lamp (2) ceases
ashing.
⇒ The drive has been “taught” successfully!
Checking the end positions door OPEN + CLOSED
The trolley of the drive system can be extended or shortened by means
of the switch triggers.
Check that the door opens and closes completely. If it does not, readjust
the trolley.
1
2
1. Actuate the control device (e.g.: push-button, hand-held transmitter, etc.)
once.
⇒ The door opens to end position “door OPEN”.
2. Check that the door has reached the desired end position.
⇒ Readjust the end positions if necessary. See chapter “Commissioning
– setting door OPEN + CLOSED end positions”.
Commissioning