Operation Manual

Installation
13
Fitting and connecting
push-buttons
CAUTION!
Position the push-button in such a way that the operator can
see the door, while he/she is not inside the operating area
of the door.
CAUTION!
Control or regulating units in a xed position must be
mounted within sight of the door. They may not, however,
be mounted close to moving parts and must be at least
1.5 m above the ground.
NOTE!
Never run the push-button cable (length 7 m) along a power
cable as this can cause the control unit to malfunction.
The control unit is shipped with the push-button cable
connected. Lay push-button cable and secure in position.
1,5 m
2
1
22
Install push-button (1) in an appropriate, easily accessible location
inside the garage. Minimum height from oor: 1.6 m.
Install the push-button cable (2) in the garage. Connect end of cable
to the push-button (1).
Installing the socket outlet
CAUTION!
Socket may only be installed by a qualied electrician.
Protect socket with a fuse (16 A slow-blow type).
Observe all applicable regulations (e.g. VDE, etc.)!
23
ca. 0,5 m
11
3
2
Install socket (1) on ceiling at a distance of approx. 0.5 metres to the
control housing (2). Install and connect the line from the power socket (1)
to the power mains.
CAUTION!
Do not plug the power supply (3) into the socket outlet yet!
RISK OF INJURY!
The force setting is relevant to the system's safety and
must therefore be carried out with due care and attention.
An excessively high force setting can injure people and/or
animals and damage property.
Select as low a force setting as possible to ensure that
obstacles are identied in a fast, safe manner.
RISK OF SUDDEN CLOSING OR OPENING!
When the emergency release is actuated, the door might
suddenly be opened or closed, due to a damaged spring
or incorrect balance weight. This might damage or even
destroy the drive unit.
CAUTION!
After installation, it is imperative to check whether the drive
stops when it encounters a 20 kg load that attached to the
middle of the bottom edge of door.
CAUTION!
After installation, ensure that no parts of the door protrude
into public footpaths or streets.
NOTE!
Once the drive has been installed, the person responsible
for installation has to issue an EU Conformity Declaration
for the door system in accordance with Machine Directive
2006/42/EC as well as tting the CE seal and the rating plate.
This also applies to doors installed for private purposes and
in cases where the drive has been retrotted to a manual
door. These instructions as well as the drive's installation
and operating instructions should be kept by the user for
reference purposes.
22
23