Installation Instructions

68
46900V001_Rev-D_EN
15. Maintenance and care
15.3 Care
Clean track, motor carriage and ceiling control unit
1. Pull the power plug out of the power socket.
If an accumulator has been installed, remove the
control unit cover and disconnect the accumulator
from the control unit, see also Chapter "11.11
Installing and removing the accumulator."
Then check that the power is disconnected.
2. Remove loose dirt with a moist, lint-free cloth:
• from the motor carriage and the ceiling control unit
• from the track and the inside of the track
• If required, install the accumulator in reverse order of
removal.
3. Re-connect the operator to the mains voltage. Check
the power supply.
⇒ The operator is supplied with voltage.
Cleaning the photocell
Fig. 1
NOTE
Do not change the position of the photocell
when cleaning it.
1. Clean the housing and reflectors of the photocell with
a damp, lint-free cloth.