Installation Instructions

47
46900V001_Rev-D_EN
10. Connections and special functions of the motor
carriage
INFORMATION
If the wicket door is opened, the operator
lighting on the motor carriage switches
on. If the door closes, the operator lighting
lights up for the set burning time and then
switches off. The burning time can be
modied with SOMlink and a WiFi-enabled
device.
INFORMATION
If the wicket door remains open longer
than 60 minutes, the operator lighting
switches off automatically after 60 minutes.
This value can be changed via SOMlink
and a WiFi-enabled device.
INFORMATION
If the control unit receives a new command
with the wicket door open, the LEDs of the
operator lighting change from permanent
to blinking light.
10.20 12 V output
The use of the 12 V output depends on the version of the
motor carriage circuit board.
This output can be used for the power supply of external
accessories. The 12 V output offers 2 operating modes.
12V DC, max. 100 mA are available for them
8K2
+12V
br
gn
wh
+12V
OSE
8
K
b
r
g
n
+
12
V
O
S
E
Fig. Output 12 V
Operating mode 1 (factory setting)
Power supply for external devices, for example finger
scanners mounted in the door panel.
INFORMATION
Power-saving mode must be deactivated
for this operating mode. Set DIP switch
3 on the ceiling control unit to ON.
See Chapter "14.5 Power-saving mode."
Operating mode 2 (external lighting)
In this operating mode, external lighting can be
connected and switched via the CH2 radio channel, for
example lighting with LEDs. This operating mode can
only be activated via SOMlink and a WiFi-enabled device.
In the "External lighting" operating mode, the OSE/8K2
safety device can no longer be used on the motor
carriage.
INFORMATION
If the "External lighting" operating mode
is used, the operator lighting works with
reduced illumination power.
10.21 SOMlink
SOMlink makes it possible for qualified specialists
to change many functions and settings on the door
operator. These include force and speed values as well
as operating parameters and other convenient functions.
If you would like to make changes, contact your specialist
dealer.
INFORMATION
SOMlink is a combination of an additional
device and a web-based application for
changing door operator functions.
Since safety-relevant values can also be
changed, SOMlink is only sold to qualied
specialists.
All changes to settings by the SOMlink are
logged.
INFORMATION
All operator parameters are reset to
the factory settings by a factory reset.
All settings via SOMlink and WiFi-enabled
device are also reset.
The DIP switches can only be manually
reset.