Installation Instructions

43
46900V001_Rev-D_EN
10. Connections and special functions of the motor
carriage
10.12 Programming a second transmitter
by radio (HFL)
Prerequisites for teach-in by radio
A handheld transmitter must already be programmed
on the radio receiver. The handheld transmitters used
must be identical. So, for example, a Pearl can only be
programmed on a Pearl and a Pearl Vibe on a Pearl Vibe.
The key assignment of handheld transmitter (A) that
put the radio receiver into teach-in mode by radio is
used for the new handheld transmitter (B) that is to be
programmed.
The already-programmed transmitter and the new
transmitter to be programmed must be situated in the
range of the radio receiver.
Example:
1. Button 1 on radio channel 1 and button 2 on radio
channel 2 have been programmed by handheld
transmitter (A).
⇒ The newly-programmed transmitter (B) adopts
the key assignment of transmitter (A): Button 1 on
radio channel 1, button 2 on radio channel 2.
Restriction
The following setting is not possible:
• The targeted teach-in of a selected handheld
transmitter button on a radio channel.
1
2
A
3
B
Fig. 1
1. Press buttons 1 + 2 of a programmed handheld
transmitter (A) for 3 - 5 seconds until the LED briefly
lights up on the handheld transmitter.
⇒ Theoperatorlightingashes.
2. Release buttons 1 + 2 of the handheld transmitter (A).
⇒ If a radio command is not transmitted within
another 30 seconds, the radio receiver switches
over to normal mode.
3. Press any key, e.g. (3) on the new handheld
transmitter (B) to be programmed.
⇒ The LEDs of the operator lighting remain steady.
10.13 Resetting the control unit
15 s1 s 5 s 10 s
Reset of the
safety inputs
Force values
deleted
Position
values and
frame photo
eye deleted
Settings
restored
Fig. Overview of the time sequence of the motor carriage status
LED when pressing the green reset button
RADIO
RESET
CH1
CH2
CH3
CH4
STATUS
ON
1
2
3
4
Fig. 1
INFORMATION
A SOMlink and a WiFi-enabled device
are required to reset all parameters to
the factory settings.
Resetting the safety devices
1. Press the green reset button for 1 second.
⇒ Reset of the connected safety devices.
⇒ Subsequently attached safety devices are
detected.
Deleting the force values
1. Press the green reset button on the motor carriage
for 5 seconds until the green status LED flashes
slowly.
⇒ Force values are deleted.
Deleting force and position values
1. Press the green reset button on the motor carriage
for 10 seconds until the green status LED flashes
quickly.