Installation Instructions

29
46900V001_Rev-D_EN
6. Installation
“clic”
Fig. 13
13. Pull the emergency release cord once to unlock the
motor carriage.
Slide the motor carriage forward to the door.
5 mm
Fig. 14 Fig. 15
WARNING
Risk of injury in the head region!
Impact with suspended objects may
cause serious abrasions and cuts.
► You must wear a safety helmet when
installing suspended parts.
14. Plug the push arm into the door bracket. Insert the
bolt and slide on the safety bolt.
Plug the push arm into the front of the motor carriage.
Also insert the bolt and slide on the safety bolt.
15. Align the door bracket with the centre of the door.
Mark the position of the holes and drill them
(Ø 5 mm). Fix the door bracket to the door with the
hexagon bolts.
⇒ The push arm is attached to the motor carriage
and the door.
“clic”
Fig. 16
NOTE
The door must not rub against the operator
or tracks. This could damage the operator
or tracks.
The operator must then be offset.
16. Open the door completely by hand.
If the door rubs against the operator or the tracks,
the operator must be offset.
⇒ The guide idler moves automatically with the motor
carriage.
Fig. 17
NOTE
Do not push the door all the way to the
mechanical stop. This is because the
operator will then pull the door against the
mechanical stop. This will apply tension to
the door and it may be damaged.
A clearance of about 30 mm is required.
INFORMATION
The guide idler can be subsequently
pushed under the chain and screwed into
the track.
Then screw the guide idler tightly to the
track at the respective spot.
17. Tighten the screw on the guide idler with a Phillips
screwdriver without changing its position.
Check the door OPEN end position: