Installation Instructions
20
46900V001_Rev-D_EN
5. Declaration of Installation
Declaration of Installation
for the installation of an incomplete machine
in accordance with the Machinery Directive 2006/42/EC, Annex II, Section 1 B
SOMMER Antriebs- und Funktechnik GmbH
Hans-Böckler-Straße 21-27
73230 Kirchheim
Germany
hereby declares that the control units
S 9050 base; S 9060 base; S 9080 base; S 9110 base; S 9050 base+ S 9060 base+; S 9080 base+; S 9110 base+;
S 9050 pro; S 9060 pro; S 9080 pro; S 9110 pro; S 9050 pro+; S 9060 pro+; S 9080 pro+; S 9110 pro+
have been developed, designed and manufactured in conformity with the:
• Machinery Directive 2006/42/EC
• Low Voltage Directive 2014/35/EU
• Electromagnetic Compatibility Directive 2014/30/EU
• RoHS Directive 2011/65/EU
The following standards were applied:
• EN ISO 13849-1, PL "C" Cat. 2 Safety of machines - safety-related parts of controls - Part 1: General
design guidelines
• EN 60335-1, where applicable Safety of electrical appliances/operators for doors
• EN 61000-6-3 Electromagnetic compatibility (EMC) - interference
• EN 61000-6-2 Electromagnetic compatibility (EMC) - interference resistance
• EN 60335-2-95 General safety requirements for household and similar electrical appliances
- Part 2: Particular requirements for operators for vertically moving garage
doors for residential use
• EN 60335-2-103 General safety requirements for household and similar electrical appliances
- Part 2: Special requirements for operators for gates, doors and windows
The following requirements of Annex 1 of the Machinery Directive 2006/42/EC are met:
1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.2.3, 1.2.4, 1.2.5, 1.2.6, 1.3.1, 1.3.2, 1.3.4, 1.3.7, 1.5.1, 1.5.4, 1.5.6, 1.5.14, 1.6.1,
1.6.2, 1.6.3, 1.7.1, 1.7.3, 1.7.4
The special technical documents have been prepared in accordance with Annex VII Part B and are submitted
electronically to the regulators on request.
The operator may only be used:
• incombinationwithdoortypesinthereferencelistwhichcanbefoundundercertications.
www.sommer.eu
The incomplete machine is intended for installation in a door system only to form a complete machine as defined by
the Machinery Directive 2006/42/EC. The door system may only be put into operation after it has been established
that the complete system complies with the regulations of the above EC Directive.
The undersigned is responsible for compilation of the technical documents.
Kirchheim, 20-04-2016
i.V.
Jochen Lude
Responsible for documents