Installation Instructions

74
46900V001_Rev-D_EN
17. Taking out of operation, storage and disposal
17.1 Taking the operator out of
operation and disassembly
Follow the basic safety instructions listed below.
People under the influence of drugs, alcohol, or
medications that can influence their ability to react may
not work on the operator.
The disassembly and disposal of the operator may only
be performed by a qualified specialist.
This installation and operating manual must be read,
understood and complied with by the qualified specialist
who disassembles the operator.
DANGER
Danger if not observed!
If safety instructions are not observed,
serious injury or death may result.
► All safety instructions must be complied
with.
DANGER
Danger due to electric current!
Contact with live parts may result
in electric current owing through
the body. Electric shock, burns or death
will result.
► All disassembly work on electrical
components may only be carried out
by a trained electrician.
► Disconnect the power plug before
disassembling the operator.
► If an accumulator is connected,
disconnect it from the control unit.
► Check that the operator is not live.
► Secure the operator against being
switched back on.
WARNING
Danger of falling!
Unsafe or defective ladders may tip and
cause serious or fatal accidents.
► Use only a non-slip, stable ladder.
► Ensure that ladders are safely
positioned.
WARNING
Danger of tripping and falling!
Unsafely positioned parts such as
packaging, operator parts or tools may
cause trips or falls.
► Keep the installation area free of
unnecessary items.
► Place all parts where no-one is likely to
trip or fall over them.
► The general workplace guidelines must
be observed.
WARNING
Danger due to optical radiation!
Looking into an LED at short range for
an extended period may cause optical
glare. This may temporarily reduce
vision. This may cause serious or fatal
accidents.
► Never look directly into an LED.
WARNING
Danger due to hot surfaces!
After frequent operation parts of the
motor carriage or the control unit may
become hot. If the cover is removed and
hot parts are touched, they may cause
burns.
► Allow the operator to cool down before
removing the cover.
WARNING
Risk of eye injury!
Eyes and hands may be seriously
injured by chips when removing screws.
► Wear safety glasses.
WARNING
Risk of injury in the head region!
Impact with suspended objects may
cause serious abrasions and cuts.
► You must wear a safety helmet when
disassembling suspended parts.