Installation Instructions

65
46900V001_Rev-D_EN
NOTE
In an emergency release, the door could
open or close by itself surprisingly quickly
due to a broken spring or incorrect setting
of the weight balancing.
Damage to the door system could occur.
NOTE
After the operator is locked back in, move
the door into the door OPEN end position.
Otherwise the guide idler will be hit with
too much force.
NOTE
Objects in the movement area of the door
may be jammed and damaged.
Objects must not be in the range of
movement of the door.
INFORMATION
It can be locked and released in any door
position.
1. Disconnect the operator from the mains voltage.
Check it is disconnected from the power supply.
“clic”
Fig. 1 Fig. 2
2. Pull once on the emergency release cord.
⇒ The motor carriage is released.
⇒ Door can be moved by hand.
14. Operation
3. Pull the emergency release cord once more.
⇒ The motor carriage is locked.
⇒ The door can only be moved by the operator.
4. Connect the operator to the mains voltage.
Check that the power supply is connected.
5. Give the operator a command.
⇒ Afterapowerfailure,therstpulseoftheoperator
is always in the door OPEN direction.
⇒ The operator must drive completely to the door
OPEN end position.