Installation Instructions

62
46900V001_Rev-D_EN
14. Operation
NOTE
Objects in the movement area of the door
may be jammed and damaged.
Objects must not be in the range of
movement of the door.
INFORMATION
Keep this installation and operating manual
accessible to all users at the place of use.
14.2 Handover to the user
The user must ensure that the CE mark and the type
plate have been attached to the door system.
The following documents for the door system must be
handed over to the user:
• the installation and operating manuals for the
operator and the door
• inspection book
• EC Declaration of Conformity
• handover protocol
The qualified specialist must instruct the user:
• on the operation of the operator and its dangers
• on the handling of the manual emergency release
• on regular maintenance, testing and care which the
user can carry out
The user must be informed about which work must only
be performed by a qualified specialist:
• installation of accessories
• settings
• regular maintenance, testing and care which can
be carried out by the user, except that described in
Chapter "15. Maintenance and care"
• Troubleshooting measures which can be carried
out by the user, except those described in Chapter
"16. Troubleshooting"
The user is responsible for:
• the intended use of the operator
• its good condition
• operation
• instructing all users how to use the door system and
in the associated hazards
• the handling of the manual emergency release
• maintenance, testing and care
• testsbyaqualiedspecialist
• troubleshootingincaseoffaultsbyaqualied
specialist
WARNING
Danger of crushing and shearing!
If the door moves and there are persons
or animals in the movement area,
crushing and shearing injuries may be
caused by the mechanism and safety
edges of the door.
► Only use the operator when you have a
direct view of the door.
► All danger zones must be visible during
the entire door operation.
► Always keep the moving door in sight.
► Keep persons and animals clear of the
range of movement of the door.
► Never put your hand near the door
when it is moving or near moving parts.
In particular, do not reach into the
moving push arm.
► Do not reach into the ceiling suspension
unit when the motor carriage is running
along the track.
► Do not drive through the door until it has
opened completely.
► Never stand under the opened door.
WARNING
Danger due to optical radiation!
Looking into an LED at short range
for an extended period may cause
optical glare. This may temporarily
reduce vision. This may cause serious
or fatal accidents.
► Never look directly into an LED.
NOTE
If the weight compensation of the door is
incorrectly adjusted, the operator may be
damaged.
• The door must be stable.
• It must not bend, rotate or twist when
opening and closing.
• The door must move easily in its tracks.
Defects must be repaired without delay by
a qualied specialist.