Installation Instructions

42
46900V001_Rev-D_EN
10. Connections and special functions of the motor
carriage
10.7 Cancelling programming mode
1. Press the radio button until all LEDs are out or make
no input for 30 seconds.
⇒ Programming mode is cancelled.
10.8 Deleting a transmitter button from
the radio channel
1. Press the radio button repeatedly to select the
required radio channel.
Press and hold the radio button for 15 seconds.
LED
1 x 2 x 3 x 4 x
CH 1
CH 2
CH 3
CH 4
⇒ TheLEDashesafter15seconds.
2. Release the radio button.
⇒ The radio receiver is in deletion mode.
3. Press the transmitter button for which the command
is to be deleted in the radio channel.
⇒ LED goes out.
⇒ The deletion procedure is ended.
Repeat the process for additional buttons as required.
10.9 Deleting transmitter completely
from the receiver
1. Press and hold the radio button for 20 seconds.
⇒ TheLEDashesafter15seconds.
⇒ Afteranother5secondstheashsequence
changestoashing.
2. Release the radio button.
⇒ The radio receiver is in deletion mode.
3. Press any button on the transmitter that is being
deleted.
⇒ LED goes out.
⇒ The deletion procedure is completed.
⇒ The transmitter is deleted from the radio receiver.
Repeat the process for additional transmitters as
required.
10.10 Deleting radio channel in the
receiver
1. Press the radio button repeatedly to select the
required radio channel.
Press and hold the radio button for 25 seconds.
LED
1 x 2 x 3 x 4 x
CH 1
CH 2
CH 3
CH 4
⇒ TheLEDashesafter15seconds.
⇒ Afteranother5secondstheashsequence
changestoashing.
⇒ After another 5 seconds, the LED of the selected
radio channel remains steady.
2. Release the radio button.
⇒ The deletion procedure is ended.
⇒ All programmed transmitters on the selected radio
channel are deleted from the radio receiver.
10.11 Deleting all radio channels in the
receiver
1. Press and hold the radio button for 30 seconds.
⇒ TheLEDashesafter15seconds.
⇒ Afteranother5secondstheashsequence
changestoashing.
⇒ After another 5 seconds, the LED of the selected
radio channel remains steady.
⇒ After another 5 seconds all LEDs light up.
2. Release the radio button.
⇒ All LEDs are off after 5 seconds.
⇒ All programmed transmitters are deleted from
the receiver.
⇒ Receiver is completely deleted, this also applies if
the Memo is plugged in.