Installation Instructions

37
46900V001_Rev-D_EN
9.3 Detecting obstacles during the
force programming run
If the door detects an obstacle during its first door
CLOSE movement and the force programming runs
cannot be completed, the door stops.
NOTE
Check the travel path, mechanism, spring
tension and the weight balance to prevent
damage to the door system.
1. Press and hold button 1 on the handheld
transmitter.
⇒ The motor carriage jerks briey and moves in
the door CLOSE direction until the desired end
position has been reached.
2. Release button 1 on the handheld transmitter.
3. Fine adjustment:
Press and hold button 1 on the transmitter until the
motor carriage jerks briefly.
Release button 1 on the handheld transmitter.
3.1 The process can be repeated until the desired end
position is reached.
Press button 1 on the handheld transmitter briefly
(< 1 second) to save the door CLOSE end position.
⇒ The motor carriage starts the automatic force
programming runs for the door OPEN end position.
⇒ The motor carriage starts the automatic force
programming runs for the door CLOSE end
position.
If an obstacle is detected again, the motor carriage stops
and reverses a short distance.
1. Press and hold button 1 on the handheld
transmitter.
⇒ The motor carriage starts without jerking, because
the end position of the door is already saved.
⇒ The motor carriage moves to the end position.
2. Release button 1 on the handheld transmitter.
3. Press button 1 on the handheld transmitter briefly.
⇒ Restart automatic force programming runs.
⇒ On completion of the force programming runs
the motor carriage automatically moves to the
door OPEN end position.
⇒ The LEDs of the operator lighting remain steady.
⇒ Operator is programmed and ready for use.
9. Commissioning
9.4 Mechanical adjustment of the end
positions
Increasing the closing pressure of the end position
for door CLOSE
Fig. 1
1. Loosen the screw on the guide idler and move the
guide idler a few millimetres towards door CLOSE.
Re-tighten the screw.
2. The function of the emergency release must be
checked in the door CLOSE end position. Unlocking
must be possible.
Reducing the closing pressure of the end position for
door CLOSE
Fig. 1
1. Loosen the screw on the guide idler and move the
guide idler a few millimetres towards door OPEN.
Re-tighten the screw.
NOTE
Do not push the door all the way to the
mechanical stop. This is because the
operator will then pull the door against the
mechanical stop. This will apply tension to
the door and it may be damaged.
A clearance of about 30 mm is required.