Installation Instructions

36
46900V001_Rev-D_EN
< 1100 mm
Fig. 1
1. Compare the existing power supply with the type
plate.
Connect the operator with the mains voltage.
⇒ ThestatusLEDofthemotorcarriageashes
green.
Fig. 2
2. After the operator has been connected to the power
supply, its first movement after a pulse is always
door OPEN.
Press button 1 briefly on the preprogrammed
handheld transmitter. See also the separate
instructions for the "Handheld transmitter".
⇒ The motor carriage moves slowly to the
door OPEN end position and automatically
switches off at the guide idler.
⇒ Theoperatorlightingashes.
Fig. 3
3. Press button 1 on the handheld transmitter again
briefly.
⇒ The motor carriage moves slowly in the door
CLOSE direction.
⇒ Theoperatorlightingashes.
The motor carriage switches off automatically
when it reaches the factory-set closing force at the
door CLOSE end position.
⇒ Theoperatorlightingashesinadifferentsequence.
Fig. 4
4. Press button 1 on the handheld transmitter briefly
(< 1 second) to save the end position.
⇒ Theoperatorlightingashesbrieyinafast
sequence.
The operator automatically starts its
programming process:
⇒ The motor carriage moves automatically to the
door OPEN end position again and programs the
required operating force.
⇒ The motor carriage automatically moves to the
door CLOSE end position.
If necessary, the motor carriage moves over the
path several times for programming with a greater
door weight.
⇒ The motor carriage automaticallymovesbrieyin
the door OPEN direction to program the soft run.
⇒ The door automatically returns to the door
CLOSE end position.
⇒ The motor carriage automatically moves to the
door OPEN end position.
⇒ The LEDs of the operator lighting remain steady.
⇒ Operator is programmed and ready for use.
INFORMATION
The motor carriage stops if the door is
difcult to move. The door mechanism must
be checked, see Chapter "9.3 Detecting
obstacles during the force programming
run."
It may be necessary to readjust the end positions,
see Chapter "9.4 Mechanical adjustment of the end
positions".
9. Commissioning