Installation Guide

33
6. Connection and special functions of the wall control unit
the left or on the right side.
If the safety sensors are exposed to direct sunlight, the re-
ceiver (red sticker) should be installed on the side facing
away from the sun.
For garages with multiple doors (top view)
Fig. Installation on multiple doors
Install the safety sensors as shown in the diagram.
A = receiver (red sticker), B = transmitter (green sticker).
In this way, the safety sensors cannot influence each other
through stray light.
6.7 Installation
2”
2”
2”
1
2
2
2
1
3
Ø 3/16”
3/4”
Fig. 1 Fig. 2
1. Look for a suitable installation position for the mounting
bracket (1) inside the garage to the left and the right of
the door.
Hold the mounting bracket (1) to the wall and mark the
mounting points. The distance from the bottom edge
of the installation bracket to the floor is 2" (50 mm).
The height and angle of the bracket can be adjusted
through the slotted holes (2).
2. Drill holes for the screws. (3).
Screw in two screws (3).
WARNING
Risk of eye injury!
&KLSVÀ\LQJZKHQGULOOLQJPD\FDXVHVHULRXV
injuries to eyes and hands.
` Wear safety glasses when drilling.
6.6 Installation requirements and
dimensions
1"
<20’
< 20’
<20'
1"
Fig. Installation of safety sensors
DANGER
Danger of crushing and shearing!
If the assembly conditions are not complied
with during installation, malfunctions and error
messages may result when the safety sensors
is operated. This may result in serious injury or
even death.
The following assembly conditions must be
complied with:
` Select an installation location outside the
range of the opener and door mechanism.
` &RPSO\ZLWKDOOVSHFL¿HGLQVWDOODWLRQFRQGL-
tions and installation dimensions.
NOTE
If the following installation conditions and instal-
lation dimensions are not observed, malfunctions
and error messages may result.
$OOVSHFL¿FDWLRQVIRULQVWDOODWLRQRIWKHVDIHW\VHQ-
sors must be complied with.
NOTE
Never route the cable connection between the
safety sensors and the wall control unit along a
power supply line. This can cause the wall control
unit to malfunction. Observe the length of the
connection cable between safety sensors and wall
FRQWUROXQLW5RXWHWKHFDEOH¿UPO\
The safety sensors must be correctly connected and
aligned before the garage door opener will move in the
downward direction. Do not mount the safety sensors in
the area of the moving garage door. Mount at least 1"
(25 mm) away from it.
The distance between the transmitter and receiver of the
safety sensors set can range up to a maximum of 20'
(6.10 m).
The distance from the floor must be selected so that an ob-
stacle of 6" (152 mm) hight can be reliably detected. This
corresponds to a distance of 2" (50 mm) from the bottom
edge of the installation bracket to the floor.
The safety sensors kit consists of a transmitter (green
sticker) and a receiver (red sticker). Mount one safety sen-
sor to the left and one to the right of the door. As a general
rule, it does not matter which safety sensor is installed on