User's Manual

ManualsBrandsSOMMER Antriebs- und Funktechnik ManualsElectronicsReceiver module, e.g. for garage door operator

Table Of Contents

54 en

Troubleshooting

Only use original manufacturer replacement parts, acces-

sories and mounting material.

Replacing light bulbs

WARNING

There is the risk of injury or death through electrical voltage if

you accidentally reach into the lamp socket when the drive is

switched on.

You must disconnect the drive from the power supply before

you replace the light bulb. Pull out the power plug from the

power outlet or switch off the the on-site circuit breaker or dis-

connect the on-site fuse for the circuit that supplies the drive

with voltage. Subsequently test to be sure the drive is discon-

nected from the power by switching it on (the drive must not

move).

CAUTION

There is the risk that the drive can be damaged or catch fire if

you use stronger or larger light bulbs than approved.

Use only the light bulbs specified in this manual.

The opener lighting consists of two light bulbs (each maxi-

mum 60 W, maximum 110 V, socket E26).

 Pull the power plug out of the power outlet.

Or for a direct connection to the power mains:

 Disconnect the opener from the power (switch off the cir-

cuit breaker to the opener or disconnect the fuse on the

circuit supplying the opener with voltage) and check to be

sure no voltage is present.

 Open a lamp lens (1). Press each of the lugs (2) in the

direction of the lamp lens.

 Unscrew the light bulb in a counterclockwise direction.

 Screw in a new light bulb in a clockwise direction.

 Close the lamp lens (1); the lugs must (2) snap into place.

 Plug in the power plug into the power outlet

 Switch on the the electrical supply for a direct electrical

connection (switch on the circuit breaker or fuse).

Replacing the drive fuse

DANGER

There is the possible risk of injury or death from electrical

voltage.

You must disconnect the drive from the power supply before

you replace the fuse. Pull out the power plug from the power

outlet or switch off the the on-site circuit breaker or discon-

nect the on-site fuse for the circuit that supplies the drive with

voltage. Subsequently test to be sure the drive is discon-

nected from the power by switching it on (the drive must not

move).

CAUTION

There is the possible risk that the drive can be damaged or

catch fire if you other fuses than the ones approved.

Use only the fuses specified in this manual.

 Pull the power plug out of the power outlet.

Or for a direct connection to the power mains:

60W,E26

“clic”