User's Manual

50 en
Troubleshooting
Drive does not open or close
the door after pressing a but-
ton on the remote control.
Lighting on the drive does not
function.
Drive stops while the door is
closing and opens the door
again completely.
9. Wall station (accessory) not
mounted and connected.
10. Broken wire/ short circuit.
11. Wall station (accessory)
incorrectly connected to the
drive.
12. Wall station (accessory)
defective.
13. Short circuit, for example
through contact with the
chain and C-rail from dam-
aged chain guide.
1. See points 1, 2, 3, 4, 5, 6, 7
above.
2. Hand-held transmitter not
programmed.
3. Hand-held transmitter
defective.
4. Battery empty.
5. Short circuit, for example
through contact with the
chain and C-rail from dam-
aged chain guide.
1. See points 1, 2 above.
2. No light bulb installed.
3. Defective light bulb.
1. Door contacted an obstacle.
2. Photoelectric barrier was
interrupted.
9. LED on the wall station
does not light up. When
connected correctly, this
lights up green.
10. LED on the wall station
does not light up
11. Drive functions with hand-
held transmitter and points
6,8,9,10,11 are OK.
12. –
13. Check the fuse in the drive.
1. See points 1, 2, 3, 4, 5, 6, 7
above.
2. “Command” LED does not
light up when the hand-held
remote control is operated.
3. LED on the hand-held
remote control does not
light up.
4. –
5. Check the fuse in the drive.
1. See points 1, 2 above.
2. Open the cover and check
whether light bulbs are
installed.
3. –
1. Check the area of the
door’s motion for possible
object present.
2. Check LED on the photo-
electric barrier and “Safety”
LED on the controller hous-
ing.
9. Mount the wall station
(accessory) and connect.
10. Repair or replace the cable.
11. Wall station (accessory)
must be connected to termi-
nal 3+4.
12. Replace the wall station
(accessory).
13. Replace fuse in the drive,
see “Troubleshooting”.
1. See points 1, 2, 3, 4, 5, 6, 7
above.
2. Program the hand-held
transmitter.
3. Replace the hand-held
remote control.
4. Replace the battery, see
“Troubleshooting”.
5. Replace fuse in the drive,
see “Troubleshooting”.
1. See points 1, 2 above.
2. Replace light bulbs, see
chapter “Using for the first
time”.
3. Replace the light bulbs, see
“Troubleshooting”.
1. Remove object.
2. Remedy the fault.
Fault/Behavior Possible causes Test/Check Remedy