User's Manual

45en
Setting the DIP switches
You can set up special functions via the DIP switches. By
default, all DIP switches are set to “OFF”. The power supply
must be switched off during the setup. The settings only
become active after the power supply has been switched on
after making the changes.
 Pull the power plug out of the power outlet.
Or for a direct connection to the power mains:
 Disconnect the drive from the power (switch off the circuit
breaker to the drive or disconnect the fuse) and check to
be sure no voltage is present.
 To set the DIP switches, slide the covering (1) in the con-
troller housing (2) outwards and remove.
 The DIP switches can be set using a small screwdriver.
 After setting the DIP switches, place the covering in the
controller housing again and slide it inwards.
 Plug the power plug back into the power outlet
or
 switch on the the electrical supply for a direct electrical
connection (switch on the circuit breaker or fuse).
1234
ON
S
AB
2
1
14
15
16
13
3
Setting the position for partial opening
You can set in which position the door stops using the “partial
open” function.
 Close the door with the drive.
 Set the DIP switch 4 to “ON“.
 Press one of the desired remote control buttons for this
function (for example button 2). The door opens. The
remote control button has to have previously “learned” this
function. See chapter Using for the first time, “Program-
ming the hand-held transmitter”.
When the desired position has been reached:
 Press the button 2 again. The door stops.
 Press the button 2 once more. The door closes.
The position for the partial opening is saved and remains
stored as long as the DIP switch 4 is set to the “ON’ posi-
tion.
Deleting the setting:
 Set the DIP switch 4 to “OFF”. The setting is permanently
deleted and must be set again if needed (using DIP
switch 4 to “ON”).
Settings