User's Manual

41en
 To unlock, press and hold the button (3) (at least 5 sec-
onds), until the illumination of the light button lights up
green (it blinks red until then).
All functions of the drive are unlocked and active.
Emergency release from the inside
In the event of a power failure, the door can be opened from
the inside using a mechanical emergency release.
WARNING
There is the possible risk of injury or death if the emergency
release is triggered with an open door.
The emergency release should preferably be used when the
door is closed. It should only be used with caution when the
door is opened. Weak or broken springs can cause the door
to close surprisingly quickly and thus increase the risk of seri-
ous injury or death.
Activating the emergency release
 Pull once on the grip of the emergency release cord (N).
The carriage (1) is unlocked and the door can be moved
by hand.
Resetting the emergency release
 Pull once on the grip of the emergency release cord (N).
The carriage (1) is engaged and the door can now only be
moved by the drive.
1
N
Indicator lights on the control housing
Description Signal Function
Radio Red (LED)
Lights up or blinks during “learn-
ing” of a remote control respec-
tive of the programming state.
See “Programming the hand-
held transmitter”. Lights up, as
long as a hand-held remote con-
trol button for starting the drive is
pressed.
Power Red (LED)
Light up when the drive is sup-
plied with voltage.
Status Red (LED)
Always blinks while the drive
opens/closes the door. If the
drive is not yet learned in, the
LED also blinks when the drive
is in the stopped state. In the
learned in state, the LED is off
when the drive is in the stopped
state.
Safety Red (LED)
Lights up if the photoelectric bar-
rier is interrupted. As long as a
correct signal is coming from the
photoelectric barrier, the LED is
off.
Command Red (LED)
Lights up if the drive is started
via a hand-held remote control
or a wall station (accessory) for
example.
Operation