User manual

17
EN - SLIDYMOOVE 300 installation and operating guide - SOMFY
EN
Commissioning and standard use
2
EN
During the auto-programming process, pressing button 1 on the remote control or the button on
the control electronics causes the gate and the auto-programming process to stop.
2.3 Standby / reactivation of the control electronics
2.4 Plugging the openings
To check if the motor is switched on or to check/
modify the parameter setting, press the
button
for 2 seconds to reactivate the electronics.
Once all the cables have been fed through, plug
the openings (ground anchoring holes, cable feed
openings) using silicone.
Once the auto-programming process has been
completed, the electronics automatically switch
to standby a;er 5 minutes of inactivity to save
energy.
In standby mode, all indicator lights are
switched off.
You are strongly advised to plug all the openings
to avoid short circuits caused by insects.
2.5 Li!ing the cover