Installation Guide

Copyright © 2018 Questech Corporation. All Rights Reserved. Part Number: INFOXXX Rev.04.02.18 | Ultra-Fresh® is a registered trademark of Thomson Research Associates.
Care and Maintenance
 To clean, use an ordinary household
cleaner. For best results, we recommend a
liquid, non-abrasive cleaner.
 Liquid abrasive household cleaners should
be used only after being tested in a small
inconspicuous area to ensure that no
damage will result.
 Do NOT clean with scouring pads, steel
wool, or other abrasive implements or
damage to the tile surface may result.
 Cleaners containing ammonia, bleach or
other harsh chemicals should be wiped up
shortly after application or damage to the
tile surface may result.
H
IGH-TEMPERATURE INSTALLATION
High-temperature installations are those where
tiled surfaces will be subject to temperatures
130°F (55°C) or greater. Common applications
include: Certain kitchen cook tops, fireplace
surrounds and steam rooms. Follow the high
temperature installation instructions to ensure
proper adhesion.
Important Note: Tiles are not recommended in
areas where the tiled surface temperature will
exceed 212°F (100°C). For example, do not
install tiles as a heat shield behind a wood (or
gas) stove.
Behind Cook-Tops without a Back-Guard (or
back mount control panel)
To ensure proper bond, maintain a minimum
distance of 4.5” inches between tiled surfaces
and heat source. For the wall area directly
behind and within 18 inches above the cooking
surface, follow the high-temperature
installation instructions.
Fireplace Surrounds
To ensure proper bond, maintain a minimum
clearance of 6" from the fireplace opening.
When used above and projecting more than
1½” from a fireplace face, maintain a minimum
clearance of 12” above the fireplace opening.
Consult state and local building codes to
determine if more clearance is required in your
area. Follow the high-temperature installation
instructions.
Steam Rooms
To ensure proper bond, follow the high-
temperature installation instructions.
High-Temperature Installation
Instructions
 Set tile with a water-cleanable epoxy
mortar conforming to ANSI A118.3.
 Grout tile with a water-cleanable grouting
epoxy conforming to ANSI A118.3.
 Follow setting and grouting instructions
found in the Installation Instructions section
of this document.