User's Manual
Table Of Contents
- Important Safety Instructions
- Overview
- The ERU assembly
- Do you have everything?
- Safety precautions
- Introduction
- Installing the ERU
- Installation overview
- Installation guidelines and requirements
- Estimating cable requirements
- Assembling the mounting bracket and pipe
- Installing the ERU on solid wood or lap siding
- Installing the ERU on brick or poured concrete
- Installing the ERU on a cinder-block or hollow wall
- Installing the ERU under the eaves
- Installing the ERU on a roof
- Attaching the ERU to the mounting assembly
- Routing and grounding the exterior cables
- Routing cable to the SOMAport
- Troubleshooting
23
Installing the ERU
4
Estimate the amount of cable required for each of the following:
Cable run Distance
One hybrid RG-6/U coaxial cable with messengered
#17 AWG copper-clad steel grounding wire
This cable, which has a grounding wire attached, runs
from the ERU to the ground block.
One RG-6/U coaxial cable
This second piece of coaxial cable (no grounding wire
attached) runs from the ground block to the SOMAport.
The two pieces of coaxial cable connect at the ground
block to create a continuous connection between the
ERU and the SOMAport.
One #10 AWG copper grounding wire
This wire runs from the ground block to the central
building ground.