User's Manual
Table Of Contents
- Important safety instructions
- Regulatory Notices
- Contents
- Introduction
- Installing the SOMAport
- An overview of the installation
- Unpacking the SOMAport
- Choosing the best location for the SOMAport
- Connecting a computer via Ethernet
- Connecting a computer via USB
- Connecting multiple computers to the SOMAport
- Connecting telephones to the SOMAport
- Connecting the power supply and powering on the SOMAport
- Testing your equipment
- Configuring network settings for Ethernet connections
- Activating full service
- SOMAport Lights
- Troubleshooting and Getting Help
- Index
46
SOMAport Setup Guide
Status light
The Status light is a bicolor light that indicates whether or not the SOMAport is
powered on and operating normally. It can be either green or amber.
It is the top light on the front panel of the SOMAport as shown below.
Status light states
The Status light can be in one of the following states.
00093
Status Light
State Description
Off The SOMAport is not plugged in.
See “The SOMAport is not getting power” on page 57.
Amber The SOMAport is performing a diagnostic test. If the light does not
start flashing after five minutes, the test has failed.
See “There is a fault condition” on page 56.
Flashing amber The diagnostic test passed and the SOMAport is connecting to the
service provider’s network.
Green The SOMAport is on and has acquired a radio channel.