User's Manual
Table Of Contents
- Important safety instructions
- Regulatory Notices
- Contents
- Introduction
- Installing the SOMAport
- An overview of the installation
- Unpacking the SOMAport
- Choosing the best location for the SOMAport
- Connecting a computer via Ethernet
- Connecting a computer via USB
- Connecting multiple computers to the SOMAport
- Connecting telephones to the SOMAport
- Connecting the power supply and powering on the SOMAport
- Testing your equipment
- Configuring network settings for Ethernet connections
- Activating full service
- SOMAport Lights
- Troubleshooting and Getting Help
- Index
28
SOMAport Setup Guide
ξ
To connect a computer to the USB port on the SOMAport
1
Insert the SOMAport Documentation and USB Drivers CD into the CD-ROM
drive on the computer.
The SOMAport Documentation window opens.
2
Plug the square connector on the USB cable into the USB port on the back of
the SOMAport.
3
Plug the flat connector into the USB port on your computer.
A hardware wizard window opens.
See the next section, βInstalling the USB softwareβ, for information about how to
complete the wizard and install the USB drivers.
00268