User's Manual Part 2

108 Part ######A revision 00a-DRAFT March 29, 2006
Macro Base Station Installation Procedures (NPM-1000)
 To configure the Ethernet switches
1 Establish a serial connection with the Ethernet switch:
i Connect a PC to the Ethernet switch using the supplied RJ-11 to DB-9 serial cable with a null
modem adapter. See Table 6.4 for pin assignments.
ii Start a serial terminal session using the settings shown in Table 6.5.
2 Log in to the Ethernet switch.
3 Restore the default settings for the Ethernet switch by typing:
switch defaults ↵
The Ethernet switch reboots.
4 Log in to the Ethernet switch.
5 Configure the switch by typing:
port config 1-4 off 100 full false ↵
port config 5-22 off 100 half false ↵
span port enable 1-26 on ↵
span port fast 5-24 on ↵
bootp enable off ↵
dhcp server enable off ↵
dhcp client enable sw0 off ↵
cos queuing algorithm strict ↵
cos queuing map 0 0 ↵
cos queuing map 1 0 ↵
cos queuing map 2 0 ↵
cos queuing map 3 0 ↵
cos queuing map 4 1 ↵
cos queuing map 5 2 ↵
cos queuing map 6 3 ↵
cos queuing map 7 3 ↵
gvrp enable off ↵
ip config sw0 switch_ip_address 255.255.255.192 1 ↵
ip gateway router0-0_ip_address ↵
ip forward off
tftpd sessions 0
↵
where:
switch_ip_address is the IP address of the Ethernet switch you are configuring
router0-0_ip_address is the IP address of the primary router
6 Change the default password:
i Type:
Parameter Setting
Baud 9600 bits/s
Data bits 8
Parity None
Stop bits 1
Flow control None
Table 6.5 Ethernet Switch Serial Port Settings