User's Manual Part 2

66 Part ######A revision 00a-DRAFT March 29, 2006
Macro Base Station Installation Procedures (NPM-1000)
Install the RFSS Modules
If the configuration of your base station does not require a full complement of RFSS modules, some
slots may be covered with filler panels.
 To insert the RFSS modules in the RF rack
1 Remove the RFSS module from its protective bag.
2 Orient the RFSS module so that the text on the front panel is right-side up.
3 Slide the RFSS module into the first available RFSS slot. The slots should be filled from bottom to top,
left to right.
4 Secure the module in the slot using four #2 Phillips thumb screws, one in each corner. Torque the thumb
screws to 12 inch-pounds.
5 Ensure that the RFSS module is secure by grasping the handle on the front panel and pulling lightly. The
RFSS module should not move.
If the RFSS module does move, ensure that the mounting screws are attached to the shelf assembly and
that the module is seated correctly. If necessary, remove the module and repeat this procedure.
6 Repeat steps 1 to 5 for the remaining RFSS modules.
!
CAUTION: Each RFSS module weighs approximately 15 kg (33 pounds).