User's Manual Part 2

78 Part ######A revision 00a-DRAFT March 29, 2006
Macro Base Station Installation Procedures (NPM-1000)
C ONNECTING THE C ABLES
This section describes the cables connecting the different systems in the base station.
NOTE: The cables are packaged according to their type. Each type of cable may be
available in different lengths to simplify cable dressing. The length of each cable is
shown on its label (typically, using a -## format that follows the item’s part number).
The actual lengths of the cables shipped with your system may differ from those
described in this document.
NOTE: Base stations supporting different numbers of sectors use similar cabling.
For example, a two-sector base station uses the same cabling as a one-sector base
station but has additional cables for use by the other sectors.
Procedure Page
Connect the PDP Power Cables 79
Connect the RFSS Signal Cables 83
Connect the Alarm Cables 85
Connect the Ethernet Cables 86
Connect the Clock Cables 87
Connect the RF Cables 88
Connect Ferrite Blocks 90