User's Manual Part 1

46 Part ######A revision 00a-DRAFT March 29, 2006
Macro Base Station Installation Procedures (NPM-1000)
 To configure the Concurrent 310 cards
1 Remove cards from their antistatic packaging at a grounded work area. Ensure that you are properly
grounded with a wrist or boot strap before handling the cards. Depending on the configuration of your
base station, you may have up to eight cards that need to be configured.
2 Ensure that the card’s BIOS settings are correct.
3 Ensure that the jumper switches are configured as shown in Table 3.6. Figure 3.3 shows the location of
the jumpers.
Figure 3.3 Concurrent 310 Switch Configuration
4 Place the cards back in their antistatic packaging until you are ready to install them in the shelves.
Serial Console Mode