User's Manual Part 1

42 Part ######A revision 00a-DRAFT March 29, 2006
Macro Base Station Installation Procedures (NPM-1000)
C ONFIGURING C ARDS
The base station can use a variety of third-party, off-the-shelf processor and Ethernet cards. The
jumpers and switches on the cards may require configurations which differ from the factory defaults.
This section provides the procedures for making the necessary alterations.
NOTE: Consult your field engineering package for information about the type,
number, and configuration of cards used in your base station.
This section describes how to configure the following cards for use in the base station.
Procedure Page
CPC4400 Ethernet Switch 43
Concurrent 310 Processor Card 45