User's Manual Part 1

March 29, 2006 Part ######A revision 00a-DRAFT 15
Chapter 1: Installation Overview
Necessary Conditions for Installation
The installation procedures in this manual assume that the following conditions have been met:
 The core servers located at the network operations center (NOC) are operational
 A backhaul connection between the base station site and NOC is installed.
 The backhaul has been tested and is connected to the site’s edge router.
 Each of the utility bus and radio sector controllers is configured in its BIOS to boot from the
correct source.
 At least one of the hard disk drives in the base station contains the required software images.
 A power supply that meets the specifications listed in “Electrical Requirements” on page 23
has been installed.
NOTE: If these conditions are not met, it is still possible to complete the physical
installation of the base station. However, you will not be able to boot the base station
and provide cell coverage until you satisfy these conditions.