User Manual

114 Part 003609A revision 01 December 16, 2002
Amosphere NPM Installation Procedures (WCS)
to 17 foot-pounds and ensure each connector is properly
weatherproofed.
iv Connect the BTS port on each bias tee to the ANT port on each RFSS
module. The ANT port is located on the rear side of the RFSS module.
v Connect the CIN port (also called Vout) on the rear side of the RFSS
module to the DC port on the bias tee.
!
CAUTION: Do not over-tighten connectors. Overtightening the
connectors may damage the cable and degrade the RF signal.