User Manual

106 Part 003609A revision 01 December 16, 2002
Amosphere NPM Installation Procedures (WCS)
 To connect the RF cables
1 Connect each RF cable. Table 4.17 shows the origin and termination point of each
cable.
NOTE: The minimum bend radius for RF cables is 2.54 cm
(1.0 inch).
Origin Termination
RF shelf 0,
RFSS module 0,
RX connector
Radio shelf 0,
left IF/RF card (slots 10–11),
RX MAIN connector
RF shelf 0,
RFSS module 0,
TX connector
Radio shelf 0,
left IF/RF card (slots 10–11),
TX MAIN connector
RF shelf 0,
RFSS module 1,
RX connector
Radio shelf 0,
left IF/RF card (slots 10–11),
RX DIV connector
RF shelf 0,
RFSS module 1,
TX connector
Radio shelf 0,
left IF/RF card (slots 10–11),
TX DIV connector
RF shelf 0,
RFSS module 2,
RX connector
Radio shelf 0,
right IF/RF card (slots 15–16),
RX MAIN connector
RF shelf 0,
RFSS module 2,
TX connector
Radio shelf 0,
right IF/RF card (slots 15–16),
TX MAIN connector
RF shelf 0,
RFSS module 3,
RX connector
Radio shelf 0,
right IF/RF card (slots 15–16),
RX DIV connector
RF shelf 0,
RFSS module 3,
TX connector
Radio shelf 0,
right IF/RF card (slots 15–16),
TX DIV connector
RF shelf 1,
RFSS module 0,
RX connector
Radio shelf 1,
left IF/RF card (slots 10–11),
RX MAIN connector
RF shelf 1,
RFSS module 0,
TX connector
Radio shelf 1,
left IF/RF card (slots 10–11),
TX MAIN connector
RF shelf 1,
RFSS module 1,
RX connector
Radio shelf 1,
left IF/RF card (slots 10–11),
RX DIV connector
Table 4.17 RF Cable Summary (1 of 2)